NEW Hat Back clamp.


Hooptech’s new Hat Back Clamp is a great alternative to using a traditional hoop to sew on the back of hats, and is compatible with most Melco, Tajima, Brother, and Toyota embroidery machines. Snap the clamp into your cap driver just like a cap frame, then simply lift the handle to open the clamp, slide the hat back inside, close and sew.

hatback action

Contact your local Embroidery Systems Canada office for more information.

Setup Instructions for Amaya/EMT-16 Users

To set up a custom hoop for your ESC Hat Back clamp, follow these instructions:

1: In Amaya OS, click on TOOLS –> HOOP SETUP

2: Click on ADD HOOP

3: Give the hoop a name (ex: “Hat Back”) and press enter

4: Click on EDIT HOOP SHAPE

5: From the drop-down menu at the top, choose CUSTOM

6: In the box marked “Number of Custom Points” enter the number 8

7: Enter the values in the boxes using the image below as a guide. (click image to enlarge)


hatback2

8: Click APPLY, then OKAY

9: Change the value listed in”Default Sew Field Margin”  and “Y Hoop Offset” (See image below)

hatback1

10: Click on CUSTOMIZE HOOP LIST, and make sure that the hoop you just created is checked off.

11: Click APPLY, and OKAY

Now the new hoop you created should show up in the hoop list in Amaya OS. Before using this custom hoop for production, load a small design, select the hat back custom hoop, and perform a few traces, moving the design to the limits of the hoop, to ensure that it is working properly.

hatback3

NOTE: Some newer versions of Amaya OS will put a rectangular box as the dotted line “traceable area” for this hoop. If that’s the case, click on “Sew Field Shape” and repeat steps 5-7 .

For Pricing and Ordering Information, call 1 888-805-8631